How to lower your water bill with simple plumbing fixes

A high water bill in Mount Pleasant, TX often traces back to a few fixable culprits. Here are the simple plumbing repairs that cut usage — starting with the one that costs nothing to check.

Summary: Before spending anything, work out whether the bill is high because of a leak or because of usage — a sudden jump with no change in household habits almost always means water is going somewhere it should not. Most high bills are found in the first two steps of this guide. The City supplies water from Lake Bob Sandlin and Lake Cypress Springs, and residential rates rose in January 2024.

Plumber checking a water meter and shut-off valve at a Mount Pleasant, TX home

Before spending anything, work out whether the bill is high because of a leak or because of usage. The City of Mount Pleasant, TX supplies water from Lake Bob Sandlin and Lake Cypress Springs, and residential rates rose in January 2024 — so a bill can climb for reasons that have nothing to do with your plumbing. But a sudden jump, with no change in household habits, almost always means water is going somewhere it should not.

Work through this list in order. Most high bills are found in the first two steps.

How to lower your water bill: check every toilet first

A running toilet is the single most common cause of a sudden bill increase. Put a few drops of food colouring in each tank, wait twenty minutes without flushing, and look in the bowl. Colour in the bowl means tank water is leaking past the flapper, and the fill valve is refilling the tank around the clock. A worn flapper and a tired fill valve are cheap parts and a short job.

Check every toilet in the house, including a guest bathroom that is rarely used — a toilet nobody looks at can run for months. Our guide to a toilet that runs constantly in Mount Pleasant, TX walks through the full diagnosis.

Read the meter to find a hidden leak

Turn off every tap, appliance, and irrigation zone in the house, then look at the water meter. Most meters have a small leak-indicator dial or triangle that spins with even a tiny flow. If it moves with everything off, water is leaving the system somewhere — a slab leak, a failed toilet fill valve, a leaking supply line, or an outdoor line.

Note the reading, wait an hour without using water, and read it again. Any movement confirms a leak. That is the point to call us: hidden leaks need leak detection in Mount Pleasant, TX with acoustic or electronic equipment, because the leak is usually under a slab or inside a wall. Slab-on-grade is the norm for newer homes in Mount Pleasant, TX, and East Texas clay soil moves enough to stress rigid pipe joints — a small leak under a slab can run for months before it shows.

Fix the drips and the running fixtures

After toilets, the next contributors are the small, constant ones:

  • Dripping faucets — a worn cartridge or washer. See our guide to fixing a dripping faucet in Mount Pleasant, TX.
  • A dripping showerhead or tub spout — usually the shower valve cartridge, and the same logic as a faucet.
  • A constantly running water softener or filtration drain — a stuck valve can send water to drain all day. We test your water first before recommending any softener or filtration work, and no hardness figure is published for Mount Pleasant, TX water.
  • An outdoor hose bibb that drips or a hose left connected — a hose left on a bibb through a freeze can split the pipe inside the wall, and the leak shows up as a high bill weeks later.

Check irrigation and outdoor water

Irrigation is the biggest legitimate water user in most Mount Pleasant, TX homes, and the easiest to waste. A broken sprinkler head, a zone stuck on, or a controller running a summer schedule into autumn can add more to a bill than any indoor leak. Walk the zones while they run, look for misting heads and pooling water, and check the controller schedule against the season.

Two local facts matter here. First, the City's September 2026 pressure event — a damaged filter at the I-30 Water Treatment Plant cut production, and the City asked residents to limit outdoor watering to midnight to 6 a.m. from 3 September 2026 — was lifted on 25 September 2026. Those restrictions are history, not current rules. Second, the City's plumbing code requires backflow protection on the potable supply to a lawn irrigation system, so any irrigation work should include the right backflow device for the setup.

Pressure and the pressure-reducing valve

High water pressure wastes water at every fixture and shortens the life of fill valves, supply lines, and water heaters. If your pressure is above the code limit, a pressure-reducing valve (PRV) at the entry brings it down — and a failing PRV can let pressure climb without any visible symptom except higher usage and parts that keep failing. If fill valves and toilet parts keep failing in your house, ask us to check the pressure before replacing the next one.

Homes in Stone Briar and Northwood, with their newer fixtures and irrigation systems, are the ones where a PRV check pays for itself fastest — the fixtures are modern, so a pressure problem is the usual suspect when they fail early. Our pipe repair service in Mount Pleasant, TX and leak repair service in Mount Pleasant, TX cover the pressure and supply side of the system too.

Get help with plumbing in Mount Pleasant, TX

Start with the toilets and the meter — those two checks find most high bills. If the meter moves with everything off, the leak is hidden and needs proper detection. Call NTP Plumbing at (903) 350-9085 — open 24 hours, Monday–Sunday.

Sources

Tagged withwater billleak detectionplumbingMount Pleasant, TXwater saving

A few answers before you start

The most common cause is a running toilet, followed by a hidden leak and an irrigation zone stuck on. Check every toilet with the dye test, then read the meter with everything off.

Turn off all taps, appliances, and irrigation, then watch the meter. If the leak-indicator dial moves, or the reading changes over an hour with no water use, water is leaving the system somewhere.

Yes — a constant drip adds up over a month, and a dripping shower valve wastes more. But a running toilet wastes far more than any faucet, so check toilets first.

In most homes, yes, during the watering season. A broken head, a stuck zone, or a controller on a summer schedule can add more to a bill than any indoor leak.

Yes. The City asked residents to limit outdoor watering to midnight to 6 a.m. from 3 September 2026 after a filter was damaged at the I-30 Water Treatment Plant, and lifted the measures on 25 September 2026.

Need plumbing help in Mount Pleasant, TX?

(903) 350-9085

A high water bill usually has a findable cause — a running toilet, a hidden leak, or a stuck irrigation zone. Call anytime — open 24 hours, Monday–Sunday.